For most Toronto homes and condos, engineered hardwood is the better choice. It moves less with our humid summers and dry winters, works over concrete and radiant heat, and still gives you a real oak surface you can refinish. Solid hardwood still makes sense in a few cases. Here is how to decide.
What is the difference?
Solid hardwood is one piece of wood, top to bottom, usually ¾″ thick.
Engineered hardwood has a real hardwood top layer, the wear layer, bonded to a stable core of cross-laid wood layers. Turning the grain in each layer stops the board from expanding and shrinking as much as solid wood does. Corewood's standard plank is European oak, 7½″ wide and ¾″ thick, in lengths of 5′ to 8′.
Why it matters in Toronto
Wood takes on and gives off moisture with the seasons. Toronto swings from humid summers to very dry, heated winters. A solid board 7½″ wide can move enough to cup in July and gap in February. An engineered board of the same width stays much flatter, which is why wide plank floors are almost always engineered.
Side by side
Seasonal movement: Engineered — low. Solid — higher, especially in wide boards.
Wide planks (7″+): Engineered — yes, stable. Solid — risky.
Over concrete and in condos: Engineered — yes, glued or floated. Solid — generally no.
Over radiant heat: Engineered — yes, with the right install. Solid — not recommended.
Basements: Engineered — yes, with moisture control. Solid — no.
Refinishing: Engineered — yes, depending on wear layer. Solid — yes, several times.
Look underfoot: Both — a real wood surface.
When solid still makes sense
You are matching an existing solid floor in an older house.
Boards are narrow (under 5″) and going over a wood subfloor on an above-grade level.
You want to sand and refinish many times over a very long life.
What to look for in an engineered floor
Wear layer
The thickness of the top hardwood layer decides how many times the floor can be sanded. Ask for the number, not just "thick".
Core
A multi-layer wood core is more stable than a fibreboard core and holds fasteners and glue better. Ask what the core is made of.
Finish
Natural oil, UV-cured lacquer or a site-applied finish each change how the floor looks and how you repair it. See our guide to natural oil vs UV-cured vs site-finished floors.
Who stands behind it
Check who handles colour matching, installation and warranty claims. At Corewood, the same team finishes the boards in our Toronto workshop and installs them, and our team holds NWFA credentials.
Common questions
Can engineered hardwood be refinished?
Yes. A floor with a proper wear layer can be sanded and refinished. Oiled floors can also be refreshed with a maintenance oil without sanding.
Is engineered hardwood "real" wood?
Yes. The surface you see and walk on is solid hardwood. Only the layers underneath are built for stability.
Can I install it in a Toronto condo?
Usually, yes. Most condo boards require an acoustic underlay; check your building's rules before you order.