Natural oil and UV-cured lacquer are both factory finishes. They look, feel and age very differently. A site-applied finish is a third option, done on site after the floor goes down. Here is how the three compare, from a workshop that has done all three in Toronto homes since 2008.
The short answer
Natural oil soaks into the wood and hardens inside the fibres. The floor looks and feels like wood, matte and warm. Scratches stay small and local, and you can repair a spot without sanding the whole room.
UV-cured lacquer is a hard film cured with ultraviolet light at the factory. It is very low-maintenance day to day. When it does wear or scratch, the fix is usually sanding and refinishing a whole area.
Site-finished floors are installed raw, then sanded, stained and coated in your home. You get a seamless, flat surface with no bevel between boards, and colour mixed to match anything.
How each finish works
Natural oil
A plant-based oil is worked into the surface of the board. It bonds with the top layer of wood rather than sitting on top of it. Nothing separates your hand from the grain, which is why oiled floors look deeper and feel softer underfoot. Every Corewood Olio colour is a natural-oil finish, applied and cured in our Castlefield Avenue workshop. The Olio palette is a starting point: we mix custom colours to the project, so the options are endless.
UV-cured lacquer
Several thin coats of lacquer are rolled onto the boards and instantly hardened under UV lamps. The result is a uniform film with a consistent sheen. It resists stains well and needs little more than sweeping and damp mopping.
Site-finished
Unfinished square-edge boards are installed, then the crew sands the whole floor flat, applies stain and builds up topcoats on site. With no bevel between boards, the floor reads as one continuous surface. It is also the right choice when you need to match an existing floor exactly.
Side by side
Look: Natural oil — matte, natural, deep grain. UV-cured — even sheen, slightly "coated". Site-finished — depends on the coating chosen.
Feel: Natural oil — warm, like raw wood. UV-cured — smooth film. Site-finished — smooth film.
Daily care: Natural oil — sweep, damp mop with oil soap. UV-cured — sweep, damp mop. Site-finished — sweep, damp mop.
Scratches: Natural oil — small, blend into the grain. UV-cured — show as white lines in the film. Site-finished — show in the film.
Repair: Natural oil — spot repair with oil, no sanding. UV-cured — usually sand and recoat an area. Site-finished — individual boards can be repaired locally.
Colour options: Natural oil — our Olio palette, plus endless custom colours. UV-cured — limited to the line. Site-finished — mixed on site.
Edges: Prefinished boards (oil or UV) — bevelled edges. Site-finished — square edge, seamless.
Which one should you choose?
For most homes, we recommend natural oil. It is the finish we specialize in, and the one we put on most of our floors.
Choose natural oil if you want the floor to look and feel like real wood, you have kids, pets or heavy traffic, and you would rather touch up a scuff than refinish a room. Oiled floors wear in, not out.
Choose UV-cured if you want the lowest-effort surface and a consistent sheen, and you are comfortable with a full refinish later in the floor's life.
Choose site-finished if you want a seamless floor with no bevel between boards, or you are matching an existing floor.
What about protection beyond oil?
For high-traffic rooms that need more, we offer Fortis, our proprietary finishing system. It keeps the look of an oiled floor while adding a protective layer that can be buffed and touched up by hand over the life of the floor.
See them in person
Finish is easier to judge in your hand than on a screen. Order samples of any Olio colour, or visit our workshop at 1140 Castlefield Avenue in Toronto to see oiled, Fortis and site-finished boards side by side.